NEOTEC F372W Chain Sprocket Cover Assy repair parts are available for purchase
NEOTEC F372W Chain Sprocket Cover Assy repair parts are available for purchase
NEOTEC F372W Chain Sprocket Cover Assy repair parts are available for purchase
Roll over image to zoom in Click on image to zoom
NEOTEC F372W Chain Sprocket Cover Assy repair parts are available for purchaseNEOTEC F372W Chain Sprocket Cover Assy repair parts are available for purchaseNEOTEC F372W Chain Sprocket Cover Assy repair parts are available for purchase

Chain Sprocket Cover Assy Fit For FARMMAC F372W Chainsaw Parts 537 03 35-01

Save $10.00
Price:
$19.99 $29.99
Multiple Secure Payment Options
Quality Assurance
Free Delivery within the U.S
Easy Returns & Refunds
Hassle-Free Warranty
Professional Assistance
Secure Payments

Product Details

  • Compatibility:
    • Husqvarna Models: 362, 365, 371, 372 (Including 372XP)

  • Technical Specs:
    • Material: Reinforced thermoplastic composite
    • Design: Integrated chain tensioner system

  • Key Features:

    1. Pre-calibrated alignment pins for direct fitment
    2. Dual-layer oil-resistant gasket
    3. Universal compatibility with 3/8" & .325" pitch chains

  • Installation:
    • Torque specification: 2.8Nm ±0.5 (M4 bolts)
    • Requires original clutch drum washer (Part No. 503 79 61-01)

Note: Not compatible with 362XP models. Direct replacement for OEM 537 03 35-01 assemblies.

 

FAQS

Cold Start
  1. Add fuel (fuel mixing ratio: 25:1).
  2. Close the choke. If the machine is equipped with a primer bulb, press it 3–5 times until the bulb is filled with fuel.
  3. Pull the starter rope 3–5 times.
  4. After hearing two “coughing” sounds,
  5. Open the choke.
  6. Pull the starter rope to start the machine.
Hot Start
  1. Open the choke.
  2. Pull the starter rope to start the machine.

The issue may be caused by an incorrect fuel mixture, spark plug problems, or a clogged carburetor.

  1. Check whether the fuel mixing ratio is 25:1. If not, adjust the fuel mixture to 25:1.
  2. Check whether the fuel line is bent or blocked.
  3. Check whether the spark plug is sparking properly.
  4. Check whether the engine is flooded.
  5. Check whether there is a carburetor malfunction.
  1. Confirm whether the spark plug is producing a spark: Remove the spark plug, connect it to the ignition coil, and place the spark plug electrode in contact with a metal part of the machine. Pull the starter rope and observe whether the spark plug produces a spark during starting.
  2. Check the electrode gap. The correct gap is 0.5–0.7 mm (approximately the thickness of a credit card).
  3. Clean oil residue and debris from the surface of the spark plug.
  4. If the engine still does not start after completing the above steps, replace the spark plug with a new one.
  5. Check whether the high-voltage wire (ignition coil lead) is damaged.
  1. Remove the spark plug.
  2. Turn the machine upside down.
  3. Pull the starter rope.
  4. Drain the excess fuel from the cylinder.
  1. Remove the air filter.
  2. Use an air blower to remove dust or debris from the air filter.
  3. If it cannot be cleaned or has been used for a long time, replace the air filter.

You may also like